This stand wil work with all the different shocks from all the different scales. Be it your 5th scale Baja, Touring car, 8th scale buggy, truggy, or whatever RC you have this stand will work. The stand is tall enough to hold any shock fully extended and is stable enough to hold them upside down so they can drain. There are 4 holes each of 3 different sizes to hold any shock out there. The base is wide enough to be able to slide a container underneath to catch any fluid.

Stock Status: In Stock

Use this engine builders / tuners tool to help measure your ignition and port timing. 3 1/2" diameter laser engraved for accuracy. Use on end of crankshaft, or bolt directly to flywheel.

Stock Status: In Stock

The primary functionof this tool is to effortlessly install your boots without ripping or tearing them. Insert your dogbone into the end of your tool, add some lubrication, and effortlessly slide your boot onto the dogbone without damaging them. Other features of this tool include an easy way to center your pins while assembling aftermarket bones. The hole in the center of the tool will allow you to insert the set screw and tighten it with a hex wrench. Put the tool on the other side of your bone while using a hex wrench inserted into the cross hole for leverage, and tighten the set screw. The Team FastEddy Boot Installation tool is compatible with the HPI Stock bones, HD bones, and all available aftermarket bones.

Stock Status: In Stock

This is the VoltWatch2 on-board Receiver Battery Monitor for 4.8V and 6V NiCd and NiMH receiver packs. This mounts on the outside, so you can see at a glance the status of the receiver battery mounted inside.

FEATURES: 7-LEDs provide instant, accurate battery voltage status of Low, Safe,
or Max. Only one LED glows at a time
Small switch to select 4.8V or 6V battery
Very lightweight, only  4.3g unit can mount anywhere
Draws amazingly low current - from 4-34mA depending on the battery
voltage
Plugs into any open receiver channel using a Futaba J connector

INCLUDES: One VoltWatch2 On-Board Receiver Battery Monitor w/Futaba J plug
One 1.5"x1" piece of double sided mounting tape


SPECS:    Length: 42mm
Width:   16mm
Height:  4mm
Weight: 4.3 grams
Current Draw: approx 4-34mA
Lead Length: 198mm

Stock Status: In Stock